The theory being that asking a truss rod to remove a set bow without assistance is asking too much of it, and we need to help it out some. or at least take it past the point that it had stopped working for you. The nut should (the famous "should") tighten the truss rod down far enough now to hold the neck straight. Then retighten the truss rod slowly while the neck is still clamped. Now's a good time to lightly oil the truss rod nut and make sure the threads are in good shape. Figure-out a way to clamp the neck into a straight position (I use the surface of a table saw) and let it set for a couple of days, making sure the truss rod is still slack at that point. If it were mine, I'd slack the truss rod nut to 'neutral' (just prior to grabbing) and remove the strings. Thanks in advance for the you advice and recommendations, its much appreciated. Anyway I have gotten to the point where I can not tighten the truss rod anymore and I still have a measured action of 1/8" (4/32") at the 7th fret and would like to get the action down to 1/16" (by the way its a tune-o-matic bridge set for its lowest setting).Īfter tightening the truss rod to it's max, is there anything else that I can do to try and relieve the rest of the bow? Since the bow is so large I started tightening the truss rods in increments that are larger than recommended (1/4 - 1/2 turns). I measured the string action on the low E string at the 7th fret and the string is about 7/32" above the fret. This week I took the guitar and I put a carpenters square across the fretboard to look at the curvature of the neck and indeed there is a severe up bow. The guitar never played right, I could never play it past the 3rd fret because the action was so high. I am trying to learn about truss rod adjustments, I have an old Harmony H802 guitar (my first guitar) that has been sitting in my closet for about 20 years. I am a longtime guitar player but relatively new at doing my own set-ups.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |